Corrosion and heavy masses take their toll on the leaf springs of a Ford Ranger over time, making them lose their journey peak. You’ll ship the leaf springs to the auto restore retailer for maintenance or change them to revive the rear suspension’s potential to compress and delay when driving over bumps and holes on the freeway. Adjust to this Ford Ranger Leaf Springs Remove and Install Procedures to take away and set up the leaf springs.
Ford Ranger Leaf Springs Remove Procedures
1. Park your Ford Ranger on a troublesome, and flat floor.
2. On the aspect that you’re going to be engaged on first, Loosen the rear wheel lugs with a lug wrench .
3. Carry that rear wheel using a floor jack and assist it on a jack stand.
4. Remove the wheel/tire meeting.
5. Help the rear axle with a Excessive-Raise jack or flooring jack.
6. Remove the U-bolt nuts that protected the rear axle to the leaf spring. Use a wrench or ratchet, ratchet extension and socket.
7. Increase the U-bolts and spring plate off the leaf spring and axle.
8. Decrease the rear axle a few inches and take off the spring spacer between the leaf spring and axle, if equipped.
9. Loosen and take away the bolts securing the ends of the leaf spring to the spring hangers. Use a again up wrench to hold the bolt as you loosen and take away the retaining nut using a wrench or ratchet and socket.
10. Remove the leaf spring out of your Ford Ranger.
Ford Ranger Leaf Springs Install Procedures
1. Place the leaf spring on its mounting place and insert the model new mounting bolts and retainer nuts at each end to protected the spring to its hangers.
2. Tighten the mounting bolts using a once more up wrench and a wrench or ratchet and socket.
3. Place the spring spacer between the leaf spring and the rear axle, if equipped.
4. Elevate the rear axle with the Hello-Raise jack or flooring jack and set up the model new U-bolts, new nuts and spring plate to safe the spring to the axle.
5. Tighten the U-bolt nuts using a wrench or ratchet, ratchet extension and socket. Work in a crisscross pattern to evenly tighten the retaining nuts.
6. Remove the Hello-Carry jack or flooring jack from the rear axle.
7. Install the wheel tire meeting and tighten the wheel lugs to firmly safe the wheel/tire meeting. Use the lug wrench.
8. Now Decrease your Ford Ranger and end by tightening the wheel.
9. Substitute the opposite Ford Ranger leaf spring by following the above steps.
